NSE7_OTS-7.2.0 Fortinet NSE 7 - OT Security 7.2.0 Exam Free Dumps - Free Latest Dumps for IT Certification Exams

NSE7_OTS-7.2.0 Fortinet NSE 7 – OT Security 7.2.0 Exam Free Dumps

dumps2025-04-10T09:36:52+08:00

NSE7_OTS-7.2.0 Fortinet NSE 7 – OT Security 7.2.0 exam is one for FCSS in OT Security certification, which validates your ability to design, administer, monitor, and troubleshoot Fortinet OT security solutions. Learning NSE7_OTS-7.2.0 exam information is a required step in your preparation. There are 35 multiple-choice questions in real Fortinet NSE7_OTS-7.2.0 exam, and you have 60 minutes to answer all the questions. The available language is English. Our new cracked Fortinet NSE 7 – OT Security 7.2.0 NSE7_OTS-7.2.0 exam dumps, which can ensure you pass. Free Fortinet NSE 7 – OT Security 7.2.0 NSE7_OTS-7.2.0 exam dumps are available below.

Page 1 of 2

1. What are two benefits of a Nozomi integration with FortiNAC? (Choose two.)

Enhanced point of connection details

Direct VLAN assignment

Adapter consolidation for multi-adapter hosts

Importation and classification of hosts

2. Which three criteria can a FortiGate device use to look for a matching firewall policy to process traffic? (Choose three.)

Services defined in the firewall policy.

Source defined as internet services in the firewall policy

Lowest to highest policy ID number

Destination defined as internet services in the firewall policy

Highest to lowest priority defined in the firewall policy

3. Refer to the exhibit and analyze the output.

Which statement about the output is true?

This is a sample of a FortiAnalyzer system interface event log.

This is a sample of an SNMP temperature control event log.

This is a sample of a PAM event type.

This is a sample of FortiGate interface statistics.

4. Which three Fortinet products can be used for device identification in an OT industrial control system (ICS)? (Choose three.)

FortiNAC

FortiManager

FortiAnalyzer

FortiSIEM

FortiGate

5. Refer to the exhibit

In the topology shown in the exhibit, both PLCs can communicate directly with each other, without going through the firewall.

Which statement about the topology is true?

PLCs use IEEE802.1Q protocol to communicate each other.

An administrator can create firewall policies in the switch to secure between PLCs.

This integration solution expands VLAN capabilities from Layer 2 to Layer 3.

There is no micro-segmentation in this topology.

6. In a wireless network integration, how does FortiNAC obtain connecting MAC address information?

RADIUS

Link traps

End station traffic monitoring

MAC notification traps

7. Which three common breach points can be found in a typical OT environment? (Choose three.)

Global hat

Hard hat

VLAN exploits

Black hat

RTU exploits

8. Refer to the exhibit.

You are navigating through FortiSIEM in an OT network.

How do you view information presented in the exhibit and what does the FortiGate device security status tell you?

In the PCI logging dashboard and there are one or more high-severity security incidents for the FortiGate device.

In the summary dashboard and there are one or more high-severity security incidents for the FortiGate device.

In the widget dashboard and there are one or more high-severity incidents for the FortiGate device.

In the business service dashboard and there are one or more high-severity security incidents for the FortiGate device.

9. An OT network administrator is trying to implement active authentication.

Which two methods should the administrator use to achieve this? (Choose two.)

Two-factor authentication on FortiAuthenticator

Role-based authentication on FortiNAC

FSSO authentication on FortiGate

Local authentication on FortiGate

10. Refer to the exhibit.

An OT administrator ran a report to identify device inventory in an OT network.

Based on the report results, which report was run?

A FortiSIEM CMDB report

A FortiAnalyzer device report

A FortiSIEM incident report

A FortiSIEM analytics report

Page 2 of 2

11. An OT administrator deployed many devices to secure the OT network. However, the SOC team is reporting that there are too many alerts, and that many of the alerts are false positive. The OT administrator would like to find a solution that eliminates repetitive tasks, improves efficiency, saves time, and saves resources.

Which products should the administrator deploy to address these issues and automate most of the manual tasks done by the SOC team?

FortiSIEM and FortiManager

FortiSandbox and FortiSIEM

FortiSOAR and FortiSIEM

A syslog server and FortiSIEM

12. Refer to the exhibit.

You need to configure VPN user access for supervisors at the breach and HQ sites using the same soft FortiToken. Each site has a FortiGate VPN gateway.

What must you do to achieve this objective?

You must use a FortiAuthenticator.

You must register the same FortiToken on more than one FortiGate.

You must use the user self-registration server.

You must use a third-party RADIUS OTP server.

13. An OT supervisor has configured LDAP and FSSO for the authentication. The goal is that all the users be authenticated against passive authentication first and, if passive authentication is not successful, then users should be challenged with active authentication.

What should the OT supervisor do to achieve this on FortiGate?

Configure a firewall policy with LDAP users and place it on the top of list of firewall policies.

Enable two-factor authentication with FSS

Configure a firewall policy with FSSO users and place it on the top of list of firewall policies.

Under config user settings configure set auth-on-demand implicit.

14. An OT network architect needs to secure control area zones with a single network access policy to provision devices to any number of different networks.

On which device can this be accomplished?

FortiGate

FortiEDR

FortiSwitch

FortiNAC

15. Refer to the exhibit.

Based on the topology designed by the OT architect, which two statements about implementing OT security are true? (Choose two.)

Firewall policies should be configured on FortiGate-3 and FortiGate-4 with industrial protocol sensors.

Micro-segmentation can be achieved only by replacing FortiGate-3 and FortiGate-4 with a pair of FortiSwitch devices.

IT and OT networks are separated by segmentation.

FortiGate-3 and FortiGate-4 devices must be in a transparent mode.

16. Which three methods of communication are used by FortiNAC to gather visibility information? (Choose three.)

SNMP

ICMP

API

RADIUS

TACACS

17. An OT architect has deployed a Layer 2 switch in the OT network at Level 1 the Purdue model-process control. The purpose of the Layer 2 switch is to segment traffic between PLC1 and PLC2 with two VLANs. All the traffic between PLC1 and PLC2 must first flow through the Layer 2 switch and then through the FortiGate device in the Level 2 supervisory control network.

What statement about the traffic between PLC1 and PLC2 is true?

The Layer 2 switch rewrites VLAN tags before sending traffic to the FortiGate device.

The Layer 2 switches routes any traffic to the FortiGate device through an Ethernet link.

PLC1 and PLC2 traffic must flow through the Layer-2 switch trunk link to the FortiGate device.

In order to communicate, PLC1 must be in the same VLAN as PLC2.

18. An OT administrator is defining an incident notification policy using FortiSIEM and would like to configure the system with a notification policy. If an incident occurs, the administrator would like to be able to intervene and block an IP address or disable a user in Active Directory from FortiSIEM.

Which step must the administrator take to achieve this task?

Configure a fabric connector with a notification policy on FortiSIEM to connect with FortiGate.

Create a notification policy and define a script/remediation on FortiSIE

Define a script/remediation on FortiManager and enable a notification rule on FortiSIE

Deploy a mitigation script on Active Directory and create a notification policy on FortiSIE

19. When you create a user or host profile, which three criteria can you use? (Choose three.)

Host or user group memberships

Administrative group membership

An existing access control policy

Location

Host or user attributes

NSE7_OTS-7.2.0 Fortinet NSE 7 – OT Security 7.2.0 Exam Free Dumps

NSE7_OTS-7.2.0 Fortinet NSE 7 – OT Security 7.2.0 Exam Free Dumps

Share this post

Related Posts